Forum Title: Post plate
After some advice..... I've got a Bryce post plate fitted to my vector machine, I found the 'V' that sits on the post to hold it was to big so I cut that off and put a shaved bolt on it instead, but that wasn't strong enough and not compatible with the rock spike, so I then used a piece of small angle iron which worked well so long as the ground was softish but as soon as ground was hard it would bounce off the post...... So now I'm back to large angle iron which is fine on gate posts and strainers but it will sometimes split anything smaller like 5x3 and 3-4 rounds..... So was wondering what everyone else uses to hold the post in place....
Category: fence Post By: ANGEL BYRD (Albany, NY), 02/08/2019

Homeowner Resource Guide & Helpful Links

requestaquote Get Free Quotes callnow 888-506-9527